Limpieza de las mallas del filtro
Before you begin: Turn off the hot and cold water supply valves before disconnecting any supply lines.
Descripción general
Low water flow may be caused by debris in the faucet supply line filters or the spray wand screen. Clean these components, reconnect the faucet, and test the water flow.
What You May Need
- Cup of clean water
- Needle-nose pliers
- Wrench
Clean the Supply Line Filters
1. Turn off the hot and cold water supply valves.
2. Disconnect the faucet supply lines from the shut-off valves.
3. Place each filter hose into a cup of clean water.
4. Move each filter hose back and forth in the water for 15 seconds to loosen debris.
5. Remove the filter hoses from the cup and allow excess water to drain.
Clean the Filter Screens, If Needed
If water flow remains low, remove and clean the filter screens directly.
6. Remove each filter screen using your fingers or needle-nose pliers.
7. Place the filter screens into a cup of clean water.
8. Move each screen through the water by hand for 15 seconds.
9. Remove the screens and drain any excess water.
10. Reinstall each filter screen into the end of the filter hose. Push until it snaps into place.
Important: Reinstall the filter screens after cleaning to maintain the product warranty.
Reconnect the Supply Lines
11. Connect the supply lines to the shut-off valves.
12. Connect the faucet supply line labeled for hot water to the hot water supply stop.
13. Tighten the connections with a wrench.
14. Turn the water supply back on.
15. Check all connections for leaks.
Clean the Spray Wand Screen
If water flow is still low, clean the screen in the spray wand.
16. Unscrew the pulldown hose from the spray wand.
17. Remove the screen and O-ring.
18. Rinse debris from the screen.
19. Reinstall the screen and O-ring.
20. Thread the pulldown hose onto the spray wand and tighten it.
21. Turn on the faucet and check the water flow.
Preguntas frecuentes
Why is my faucet water flow low?
Debris may be trapped in the supply line filters or spray wand screen.
Do I need to reinstall the filter screens?
Yes. Reinstall the filter screens after cleaning to maintain the product warranty.
What should I do if water flow is still low?
Clean both the supply line filter screens and the spray wand screen, then check the water flow again.
This article includes detailed information on the Smart Faucet, also known as the U by Moen Smart Kitchen Faucet.